Call 1-800-347-9664
Water Heater Specifications
Glazing Gaskets: A continuous gasket made of special long life EPDM synthetic rubber is compressed by the glazing caps to seal out the weather. The inner glazing spline is made of high-temperature tolerant EPDM.
Glazing: Outer glazing is tempered low-iron solar glass with 91%transmittance. Inner glazing is Teflon film, known for its high temperature tolerance (525 degrees Fahrenheit) and its long term durability and stability, transmittance 96%. The 3/4” air space between glazings reduces heat loss.
Fluid Connections: Inlet and outlet connections are made of nominal 3/4” diameter Type “L” hard copper pipes. This allows for fast, leak free sweat fitting plumbing connections.
Case: The baked on bronze acrylic finish of the hard temper, T6,extruded aluminum framewall and glazing caps, alloy 6061, assures years of attractive rust-free appearance. All rivets and bolts are aluminum or stainless steel. Aluminum back sheet .025”.
Insulation: Rigid closed cell polyisocyanurate foam board, the most efficient insulation available, is used to maximize heat retention. Sides and ends of the unit have 1.5” board, R-value 10; bottom has 2” board, R-value 14; between tank tubes has 1.5” board, R-value 10.
Absorber/storage tank: Constructed entirely of copper, the 4” diameter tubes are welded to the interconnecting pipes to form a series flow pattern. The tank is pressured rated to 300psi and is coated with a high-temperature “selective” solar radiation absorption surface that maximizes heat gain and reduces heat loss.
Solar Lights & More
5640 SW 6th Place, Suite 400
Ocala, Fl 34478
352-690-9664
800-347-9664 (Toll Free)
Certified Solar Contractor
Licensed & Insured
CW-CA22619
made by: www.tctsolar.com
copyright 2008 Solar Lights & More
website by Howard Moon and Son